PROBE BUDDY SIMULATOR
OXYGEN PROBE SIMULATOR & TESTER
Probe Buddy™ is a smart testing device that checks the integrity and health ofn oxygen probes from United Process Controls and other manufacturers. It is also used to imitate the output signals of a working probe to check the scaling and operation of the process control system.
- Troubleshoot problems with your probe and control system
- Through simulation of the probe, all the elements of the control system can be verified including wiring between the probe and controller and calibration of the controller inputs
- An impedance test assesses the probe’s usability and performance
- Eliminate unnecessary replacement of non-defective probes and provide the probe vendor with troubleshooting information about system performance
- Carbon, dew point and oxygen calculations are featured in both measuring and simulation modes
Hand-held device operates as a probe test meter and a probe signal simulator
Enables non-experts to perform probe troubleshooting procedures like an expert
Accepts selectable TC and mV inputs from any oxygen probe
Outputs selectable TC and mV signals to simulate an oxygen probe
Performs a probe impedance test when connected to a probe
Computes carbon, dew point and oxygen in input and output mode
Specific probe connection cables available, no hard wiring required
Easy access connection
Still Have Questions?
Contact our engineering team for technical support and product recommendations.
Request a Quote